Tools»Database»Convert Database; Tools»Pcb Transmission Line Calculator; Tools»Pcb Differential Impedance Calculator; Tools»Netlist Editor - National Instruments Graphical User Interface Ultiboard User Manual

Appendix A Menus and Commands
Tools»Database»Convert Database
Tools»PCB Transmission Line Calculator
Tools»PCB Differential Impedance Calculator
Tools»Netlist Editor
Tools»Group Editor
Tools»Quick Layer Toggle
Tools»Renumber Parts
NI Ultiboard User Manual
Use to update your old User and Corporate databases to Ultiboard 10
format. Refer to the Converting Databases
with Parts, for more information.
Use to calculate parameters for typical printed circuit board trace
geometries. Refer to the
Chapter 6, PCB Calculators, for more information.
Use to perform calculations for two traces that carry signals that are exactly
equal and opposite (a differential pair). Refer to the
Impedance Calculator
information.
Use to remove or add nets and pads. Refer to the
section of Chapter 5,
information.
Use to set up and edit various group types. Refer to the
Group Editor section of Chapter 3,
information.
Use to toggle between the last copper layer or to the opposite copper layer
if the last layer was not copper.
Use to renumber parts in preparation for production. Refer to the
Renumbering Parts section of Chapter 8,
Manufacturing/Assembly, for more information.
PCB Transmission Line Calculator
section of Chapter 6,
Working with Traces and
Setting Up a
Preparing for
A-18
section of Chapter 4,
section of
PCB Differential
PCB Calculators, for more
Using the Netlist Editor
Copper, for more
Working with the
Design, for more
Working
ni.com