Table of Contents
Advertisement
Edit»Vertex
Edit»In-Place Part Edit
Edit»Properties
© National Instruments Corporation
•
Align Top—Aligns the top edges of the selected elements.
•
Align Bottom—Aligns the bottom edges of the selected elements.
•
Align Center Horizontal—Shifts the selected elements horizontally
so their centers are aligned.
•
Align Center Vertical—Shifts the selected elements vertically so
their centers are aligned.
•
Align to Coordinate—Displays the Enter coordinate dialog box
where you enter new coordinates for the selected element.
•
Space Across—Spaces three or more objects beside each other evenly.
•
Space Across Plus—Increases horizontal space between two or more
objects.
•
Space Across Min—Decreases horizontal space between two or more
objects.
•
Space Down—Spaces three or more objects above each other evenly.
•
Space Down Plus—Increases vertical space between two or more
objects.
•
Space Down Min—Decreases vertical space between two or more
objects.
You can add or remove vertices from all polygons, whether copper or
non-copper:
•
Add Vertex—Adds a vertex to a polygon segment.
•
Remove Vertex—Removse a vertex from a polygon.
Refer to the
Editing a Polygon
for more information.
Use to edit a part that has already been defined and placed on the board.
Refer to the
Editing a Placed Part (In-Place Edit)
Working with
Parts, for more information.
Displays the properties of the selected element. Results will differ,
depending on what is selected. If no element is selected, displays the board
properties. Properties are described throughout this guide.
Appendix A
section of Chapter 4,
A-7
Menus and Commands
Working with
Parts,
section of Chapter 4,
NI Ultiboard User Manual
Advertisement
Table of Contents
