Table of Contents
Advertisement
Place»Keep-in/Keep-out Area
Place»Group Array Box
Place»Pins
Place»Via
Place»Test Point
Place»Jumper
Place»Net Bridge
Place»Hole
© National Instruments Corporation
Use to define a polygon to restrict elements from either exiting or entering
the area. Refer to the
Chapter 5,
Working with Traces and
Use to place parts in a grid array. Refer to the
section of Chapter 4,
Working with
Used during In-Place Editing of a part to place a footprint. Refer to the
Editing a Placed Part (In-Place Edit)
Parts, for more information.
Use to place a via. Refer to the
Working with Traces and
Use to place a test point. Refer to the
Chapter 4,
Working with
Use to place a jumper. Refer to the
Chapter 4,
Working with
Places a net bridge on the design. Refer to the
Chapter 5,
Working with Traces and
Places a hole on the workspace. Refer to the
Chapter 4,
Working with
Working with Keep-in/Keep-out Areas
Copper, for more information.
Parts, for more information.
section of Chapter 4,
Working with Vias
Copper, for more information.
Working with Test Points
Parts, for more information.
Working with Jumpers
Parts, for more information.
Copper, for more information.
Parts, for more information.
A-13
Appendix A
Menus and Commands
section of
Placing a Group Array Box
Working with
section of Chapter 5,
section of
section of
Net Bridges
section of
Placing Holes
section of
NI Ultiboard User Manual
Advertisement
Table of Contents
