National Instruments Graphical User Interface Ultiboard User Manual page 57

© National Instruments Corporation
Column
Inner Pad The shape of the inner layer pad as set in the Through
Shape Hole Pin Properties dialog box. Refer to the
and Editing Through Hole Pin Properties
Chapter 4,
Bottom Pad The shape of the bottom layer pad as set in the
Shape Through Hole Pin Properties dialog box. Refer to
the
section of Chapter 4,
information.
Annular Ring The size of the annular ring for this pad as set in the
Through Hole Pin Properties dialog box. Refer to
the
section of Chapter 4,
information.
Pad Diameter The diameter of the pad as set in the Through Hole
Pin Properties dialog box. Refer to the
Editing Through Hole Pin Properties
Chapter 4,
Drill The diameter of the drill hole in the pad, as set in the
Diameter Through Hole Pin Properties dialog box. Refer to
the
section of Chapter 4,
information.
Trace The minimum clearance permitted between the pad
Clearance and traces, as set in the Through Hole Pin Properties
dialog box. Refer to the
Hole Pin Properties
with
1-41
Description
Working with Parts, for more information.
Viewing and Editing Through Hole Pin Properties
Working with
Viewing and Editing Through Hole Pin Properties
Working with
Working with Parts, for more information.
Viewing and Editing Through Hole Pin Properties
Working with
Viewing and Editing Through
section of Chapter 4,
Parts, for more information.
Chapter 1 User Interface
Viewing
section of
Parts, for more
Parts, for more
Viewing and
section of
Parts, for more
Working
NI Ultiboard User Manual