Displayed Messages - Muratec MFX-2830 Operation Manual

Hide thumbs Also See for MFX-2830:
Table of Contents

Advertisement

Displayed messages

■Common
Error message
Bypass tray size error, check the di-
rection and the size of paper
Call Service
Cannot cancel interrupt
Cannot detect paper size in bypass.
Please reset.
Check covers.
Open blinking cover and check
Close Cassette 1
Close Cassette 2
Close Cassette 3
Close Cassette 4
Copy protected
Document jam
Document jam.
Open and check the blinking
cover.
Document jam
Open and check the blinking
cover.
Continue storing?
[Yes] [No]
Continue storing?
Jam recover
Load the document.
Press START
From page: X
[Start] [Cancel]
Drum cartridge is almost empty
Interrupt canceling...
Lamp error. Call for service
Countermeasure
A paper size different from the one recognized by the machine has
been detected. Check the direction and the size of paper.
An internal error has occurred. Contact your Muratec dealer.
was pressed when interrupt cannot be canceled.
INTERRUPT
A paper size different from the one detected in the bypass tray has
been detected. Re-load the paper in the bypass tray.
If it is not detected, set the paper size.
The cover is open. Close the blinking cover.
The specified cassette is pulled out. Be sure to close the cassette.
An attempt was made to change to the Copy screen in the copy
protect mode.
The document has jammed. Take the jammed document out and
re-load it.
The document has not been fed properly. Or, the document is
jammed. Remove the document and re-load it.
The document jammed after the first page. Open the blinking cov-
er and remove the document.
Press [Yes] to continue storing.
Press [No] to start over.
To continue storing, re-load the document from the appropriate
page and press
.
START
The drum cartridge is running low. Prepare a new drum cartridge.
After canceling the interrupt, the interrupting operation has not
finished. Wait until the "interrupt icon" disappears.
The document cannot be scanned either because it is time to re-
place the document scanning lamp or because the optical system
dirty.
Contact your Muratec dealer.
Error Message
In This Case...
Maintenance and Troubleshooting
Reference page
1-32
Getting
Started
1-32
COPY
Chapter1
COPY
Chapter2
COPY
Chapter3
4-37
5-12
FAX
Chapter1
5-12
FAX
Chapter2
5-12
FAX
Chapter3
FAX
Chapter4
Common
Settings
In This
Case...
Appendix
5-27

Advertisement

Table of Contents
loading

Table of Contents