Initial Value Change List - Mitsubishi Electric FR-F700PJ Instruction Manual

4.26 Initial value change list

Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Pressing changes to the initial value
change list screen.
6.
Turning displays the parameter number
changed.
to read the present set value.
Press
Turn and press
setting
(refer to step 6 and 7 on page 61)
Turn to read another parameter.
The display returns to
parameters are displayed.
7.
Pressing in
the parameter setting mode.
 Turning
 Pressing
NOTE
 Calibration parameters (C0 (Pr. 900) to C7 (Pr. 905), C22 (Pr. 922) to C25 (Pr. 923)) are not displayed even when these are
changed from the initial settings.
 Only simple mode parameter is displayed when simple mode is set (Pr. 160 = "9999" (initial value))
 Pr. 160 is displayed independently of whether the setting value is changed or not.
 When parameter setting is changed after creating the initial value change list, the setting will be applied to the initial
value change list next time.
Parameters referred to
Pr. 160 Extended function display selection
C0 (Pr. 900) FM terminal calibration
C2(Pr. 902) to C7(Pr. 905) (Frequency setting bias/gain parameter)
C22(Pr. 922) to C25(Pr. 923) (Bias and gain of built-in frequency setting potentiometer)
appears.
to change the
Flicker Parameter setting complete!!
after all
status returns to
sets other parameters.
displays the change list again.
Refer to page 197
Refer to page 158

Initial value change list

Display
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously
appears.)
* It may take several seconds
for creating the initial value
change
flickers while creating the list.
Refer to page 188
Refer to page 284
"
list. "
291
4