Function assignment of external terminal and control
4.11.6 Detection of output frequency (SU, FU signal, Pr. 41 to Pr. 43, Pr. 870)
The inverter output frequency is detected and output at the output signals.
detection for reverse
The above parameters can be set when Pr. 160 Extended function display selection = "0". (Refer to page 197)
Performing IPM parameter initialization changes the settings. (Refer to page 85)
0 to 100%
Level where the SU signal turns ON.
0 to 400Hz
Frequency where the FU signal turns ON.
Frequency where the FU signal turns ON in reverse
0 to 400Hz
Same as Pr. 42 setting
0 to 5Hz
Set the hysteresis width for the detected frequency.
Up-to-frequency sensitivity (SU signal, Pr. 41)
When the output frequency reaches the set frequency, the
up-to-frequency signal (SU) is output.
The Pr. 41 value can be adjusted within the range 0% to
100% on the assumption that the set frequency is 100%.
This parameter can be used to ensure that the running
frequency has been reached to provide the operation start
signal etc. for related equipment.
When using the SU signal, set "1 (positive logic) or 101
(negative logic)" in Pr.190 or Pr.192 (output terminal function
selection) to assign function to the output terminal.
Output frequency detection
(FU signal, Pr. 42, Pr. 43)
The output frequency detection signal (FU) is output when
the output frequency reaches or exceeds the Pr. 42 setting.
This function can be used for electromagnetic brake
operation, open signal, etc.
Frequency detection that is dedicated to the reverse
operation can be set by setting detection frequency to Pr. 43.
This function is effective for switching the timing of
electromagnetic brake operation between forward rotation
(rise) and reverse rotation (fall) during vertical lift operation,
When Pr. 43
"9999", the Pr. 42 setting is used for forward
rotation and the Pr. 43 setting is used for reverse rotation.
When using the FU signal, set "4 (positive logic)" or "104
(negative logic)" to Pr.190 or Pr.192 (output terminal function
selection) to assign the function to the output terminal.