Table of Contents
Advertisement
Initial value change list
5.24 Initial value change list
Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at power-ON
The inverter starts up in Network operation
mode.
The monitor display appears.
2.
Press
to choose the PU operation mode.
3.
Press
to choose the parameter setting
mode.
4.
Turn
until
5.
Pressing
change list screen.
6.
Turning
displays the parameter number
changed.
Press
to read the currently set value.
Turn
and press
setting
(Refer to steps 6 and 7 on page 82)
Turn
to read another parameter.
The display returns to
parameters are displayed.
7.
Pressing
the parameter setting mode.
Turning
Pressing
NOTE
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999)
Only user group is displayed when user group is set (Pr. 160 = "1").
Pr. 160 is displayed independently of whether the setting value is changed or not.
When parameter setting is changed after creating the initial value change list, the setting will be reflected to the initial
value change list next time.
Parameters referred to
Pr. 160 User group read selection
228
appears.
changes to the initial value
to change the
after all
in
status returns to
sets other parameters.
displays the change list again.
Refer to page 197
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously appears.)
Flicker ··· Parameter setting complete!!
Display
∗ It may take several seconds for
creating the initial value change
"
list.
" flickers while
creating the list.
Advertisement
Table of Contents
