Mitsubishi Electric FR-F700PJ Instruction Manual page 284

(2) Using the setting dial like a potentiometer to set the frequency
Operation example Change the frequency from 0Hz to 60Hz during operation
Operation
1. Screen at power-ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Press to read the present set value.
" "(initial value) appears.
6.
Turn to change it to the set value "
7.
Press to set.
8.
Change Pr. 161 to the setting value of "
in the similar manner. (Refer to step 4 to 7.)
9.
Mode/monitor check
Press twice to choose the monitor/
frequency monitor.
10.
Press to start the inverter.
11.
Turn until "
The flickering frequency is the set frequency.
You need not press
REMARKS
 If the display changes from flickering "60.00" to "0.00", the setting of Pr. 161 Frequency setting/key lock operation selection may not
be "1".
 Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning the dial.
 When the frequency is changed, it will be stored in EEPROM as the set frequency after 10s.
NOTE
 When using the setting dial under general-purpose motor control, the frequency goes up to the set value of Pr.1
Maximum frequency (initial value:120Hz). When using the setting dial under IPM motor control, the frequency goes up
to the set value of the maximum motor speed (frequency).
Adjust the setting of Pr.1 Maximum frequency according to the application.
Setting the parameter unit and operation panel
(Pr. 160) appears.
".
Flicker
"
Flicker
" appears.
.
Display
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously
appears.)
Parameter setting complete!!
···
Parameter setting complete!!
···
The frequency flickers for about 5s.
4
279