DC tach. follower
Three speed selector
Motorized speed setter
Frequency meter (64mm
Not available under the IPM motor control.
Rated power consumption.The power supply specifications of the FR series manual controllers and speed controllers are 200VAC 50Hz, 220/220VAC 60Hz,
and 115VAC 60Hz.
Commercially available products
Phoenix Contact Co.,Ltd.
with insulation sleeve
0.75 (for two
Blade Terminal Product
Cable Size (mm
0.3 to 0.75
Contact the manufacturer regarding the delivery schedule, price, specifications, and other information of the products listed here.
A blade terminal with a insulation sleeve compatible with MTW wire which has a thick wire insulation.
Applicable for the terminal ABC.
(as of Feb. 2012)
Phoenix Contact Co.,
SZF 0-0,4 25
Blade Terminal Model
Applications, Specifications, etc.
For independent operation. With frequency meter, frequency
potentiometer and start switch.
For synchronous operation (1.5VA) by external signal (0 to 5V,
0 to 10V DC)
For three speed switching, among high, middle and low speed
For remote operation. Allows operation to be controlled from
several places (5VA)
For ratio operation. The ratios of five inverters can be set (3VA)
For tracking operation by a pilot generator (PG) signal (3VA)
Master controller (5VA) for parallel operation of multiple
(maximum 35) inverters.
For soft start and stop. Enables acceleration/deceleration in
parallel operation (3VA)
For continuous speed control operation. Used in combination
with a deviation sensor or synchro (5VA)
Used as an A/V converter or arithmetic amplifier (3VA)
For tracking operation. 70V/35VAC 500Hz (at 2500r/min)
For continuous speed control operation (mechanical deviation
For frequency setting. Wire-wound 2W 1k type B
Dedicated frequency meter (graduated to 120Hz). Moving-coil
type DC ammeter
For frequency meter calibration. Carbon film type B characteristic
Cat.5e cable that is compatible with TIA/EIA standards.
A flathead screwdriver suitable to push the open/close button
for UL wire
Structure, Specifications, etc.
when wiring to the control circuit.
Applicable for all