Basic Operation (Factory Setting) - Mitsubishi Electric FR-F700PJ Instruction Manual

4.1.2

Basic operation (factory setting)

Operation mode switchover
At power-ON (External operation mode)
PU operation mode
(output frequency monitor)
Parameter setting mode
parameter setting
Value change
General-purpose
Keep pressing
motor control
the setting dial
Output current monitor
(Refer to page 61)
Value change
Parameter clear
Automatic IPM parameter
[Operation for displaying faults history]
The past eight faults can be displayed using the setting dial.
(The latest fault is ended by ".".)
When no fault history exists,
While a fault is displayed:
The display shifts as follows by pressing
Output current Output voltage
(After Energization time, it goes back to a fault display.)
Pressing the setting dial shows the fault history number.
PU Jog operation mode
(After 1s)
Set frequency
is displayed
Hz
A
STOP
All parameter
clear
initialization
(Refer to page 297)
is displayed.
: Output frequency at the fault
Energization time.
Operation panel
(Example)
and frequency flicker alternately.
Frequency setting has been
written and completed!!
Output voltage monitor
Display the
present setting
(Example)
Parameter and a setting value
flicker alternately.
Parameter write is completed!!
Faults history clear
Initial value
change list
4
59