Initial Value Change List - Mitsubishi Electric FR-E720-0.1 K Instruction Manual

Initial value change list

4.26 Initial value change list

Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at powering ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Pressing
change list screen.
6.
Turning displays the parameter number
changed.
Press to read the currently set value.
Turn and press
setting
(refer to step 6 and 7 on page 57)
Turn to read another parameter.
The display returns to
parameters are displayed.
7.
Pressing
the parameter setting mode.
Turning
Pressing
NOTE
Calibration parameters (C0 (Pr. 900) to C7 (Pr. 905), C22 (Pr. 922) to C25 (Pr. 923)) are not displayed even they are changed
from the initial settings.
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999)
Only user group is displayed when user group is set (Pr. 160 = "1").
Pr. 160 is displayed independently of whether the setting value is changed or not.
When parameter setting is changed after creating the initial value change list, the setting will be reflected to the initial
value change list next time.
Parameters referred to
Pr. 160 User group read selection
C0 (Pr. 900) FM terminal calibration
C2(Pr. 902) to C7(Pr. 905) (Frequency setting bias/gain parameter)
C22(Pr. 922) to C25(Pr. 923) (Bias and gain of built-in frequency setting potentiometer)
274
appears.
changes to the initial value
to change the
after all
in status returns to
sets other parameters.
displays the change list again.
Refer to page 183
Refer to page 155
Display
PU indication is lit.
PRM indication is lit.
(The parameter number read previously appears.)
* It may take several seconds for
Flicker Parameter setting complete!!
Refer to page 174
Refer to page 267
creating the initial value change
"
list. " flickers while
creating the list.