Download  Print this page

Mitsubishi Electric FR-F700PJ Instruction Manual Page 200

Air-conditioning inverter.
Hide thumbs


Restart (PS reset) method when PU stop (PS display) is made during PU operation
PU stop (PS display) is made when the motor is stopped from the unit where control command source is not selected
(operation panel, parameter unit (FR-PU04/FR-PU07, operation panel for FR-E500 (PA02)) in the PU operation mode.
For example, when Pr. 551 PU mode operation command source selection = "9999" (initial value), the motor is stopped from
the PU (PS display) if entered from the operation panel
When the motor is stopped from the PU while the parameter unit (FR-PU04/FR-PU07) is selected as
control command source.
1) After the motor has decelerated to a stop, press
2) Press
to display
3) Press
of the parameter unit (FR-PU04/FR-PU07) to select the PU operation mode.
4) Press
of the parameter unit (FR-PU04/FR-PU07).
 When Pr. 551 = "9999", the priorities of the PU control source is parameter unit (FR-PU04/FR-PU07)  operation panel.
Do not reset the inverter while the start signal is being input.
Otherwise, the motor will start instantly after resetting, leading to potentially hazardous conditions.
Parameters referred to
Pr. 250 Stop selection
Pr. 551 PU mode operation command source selection
Misoperation prevention and parameter setting restriction
of the parameter unit (FR-PU04/FR-PU07).
reset )
Refer to page 133
Refer to page 214
in PU operation mode with the parameter unit mounted.


Table of Contents

   Also See for Mitsubishi Electric FR-F700PJ

Comments to this Manuals

Symbols: 0
Latest comments: