5.22 Initial Value Change List - Mitsubishi Electric 700 Series Instruction Manual

5.22 Initial value change list

Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at power-ON
The inverter starts up in the Network operation
mode. The monitor display appears.
2.
Change the X12 signal (Bit11) setting to "1."
X12 signal (Bit11) gives a control input
command through FL remote communication.
3.
Press to choose the PU operation mode.
4.
Press to choose the parameter setting
mode.
5.
Turn until
6.
Pressing changes to the initial value
change list screen.
7.
Turning displays the parameter number
changed.
Press to read the currently set value.
Turn and press
setting
(refer to step 6 and 7 on page 76)
Turn to read another parameter.
The display returns to
parameters are displayed.
8.
Pressing in
the parameter setting mode.
Turning
Pressing
NOTE
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999)
Only user group is displayed when user group is set (Pr. 160 = "1").
Pr. 160 is displayed independently of whether the setting value is changed or not.
When parameter setting is changed after creating the initial value change list, the setting will be reflected to the initial
value change list next time.
Parameters referred to
Pr. 160 User group read selection
appears.
to change the
Flicker Parameter setting complete!!
after all
status returns to
sets other parameters.
displays the change list again.
Refer to page 167
Initial value change list
Display
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously appears.)
∗ It may take several seconds for
creating the initial value change
"
list.
creating the list.
" flickers while
5
187