Initial Value Change List - Mitsubishi Electric FR-D720 K Series Instruction Manual

4.25 Initial value change list

Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until "
5.
Pressing
change list screen.
6.
Turning displays the parameter number
changed.
Press to read the present set value.
Turn and press
setting
R
( efer to step 6 and 7 on page 59.)
Turn to read another parameter.
The display returns to "
parameters are displayed.
7.
Pressing
the parameter setting mode.
 Turning
 Pressing
NOTE
 Calibration parameters (C0 (Pr. 900) to C7 (Pr. 905), C22 (Pr. 922) to C25 (Pr. 923)) are not displayed even when these are
changed from the initial settings.
 Only simple mode parameter is displayed when simple mode is set (Pr. 160 = "9999" (initial value))
 Pr. 160 is displayed independently of whether the setting value is changed or not.
 When parameter setting is changed after creating the initial value change list, the setting will be reflected to the initial
value change list next time.
Parameters referred to
Pr. 160 Extended function display selection
C0 (Pr. 900) FM terminal calibration
C2 (Pr. 902) to C7 (Pr. 905) (Frequency setting bias/gain parameter)
C22 (Pr. 922) to C25 (Pr. 923) (Bias and gain of built-in frequency setting potentiometer)
" appears.
changes to the initial value
to change the
" after all
in " " status returns to
sets other parameters.
displays the change list again.
Refer to page 165.
Refer to page 137.

Initial value change list

PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously
appears.)
* It may take several seconds
Alternating...Parameter setting complete.
Refer to page 156.
Refer to page 244.
Display
for creating the initial value
"
change list. "
blinks while creating the list.
4
251