Mitsubishi Electric FR-F700PJ Instruction Manual page 206

Air-conditioning inverter
Hide thumbs Also See for FR-F700PJ:
Table of Contents

Advertisement

(1)
Operation mode basics
 The operation mode specifies the source of the start command and the frequency command for the inverter.
 Basically, there are following operation modes.
 External operation mode: For inputting start command and frequency command with an external potentiometer and
switches which are connected to the control circuit terminal.
 PU operation mode: For inputting start command and frequency command with the operation panel or parameter unit
(FR-PU04 / FR-PU07).
 Network operation mode (NET operation mode): For inputting start command and frequency command with RS-485
communication through PU connector.
 The operation mode can be selected from the operation panel or with the communication instruction code.
Personal computer
Personal computer
GOT
Programmable controller
REMARKS
 Either "3" or "4" may be set to select the PU/External combined mode. Refer to page 200 for details.
 The stop function (PU stop selection) activated by pressing
PU07) is valid even in other than the PU operation mode in the initial setting.
(Refer to Pr. 75 Reset selection/disconnected PU detection/PU stop selection (page 193))
Selection of operation mode and operation location
PU operation mode
Operation panel
FR-PU07
PU connector
Network
operation mode
Control terminal
Inverter
PU operation mode
Potentiometer
External
operation mode
of the operation panel and parameter unit (FR-PU04/FR-
5 6
4
3
7
2
8
1
9
10
Switch
4
201

Advertisement

Table of Contents
loading

Table of Contents