Perform Setting To Reduce Stripes Between Passes - MIMAKI JV400-130LX Operation Manual

Perform setting to reduce stripes between passes

In case that feeding stripes cannot be resolved even though media correction
"MAPS (Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass
boundary. (Supported from the firmware ver.2.00)
• Depending on the printing condition, the effect cannot be recognized.
1
Press the
2
Press the
3
Press
4
Press the
5
Press
• Set Value : OFF, ON
6
Press the
• When you select OFF, proceed to the Step 9.
7
Press
• Set Value : -50 ~ +50%
8
Press the
9
Press the
key in LOCAL.
key.
to select [MAPS].
key.
to set ON/OFF.
key.
to change print speed.
• When you speed up, nozzle recovery effect cannot work in some cases. Use it after
checking.
key.
key several times to end the setting.
is performed, make
( P.2-22)
F UNC T I ON
S E T UP [ EN T ]
S E T UP
F E ED COMP . [ EN T ]
S E T UP
MA PS [ EN T ]
MA PS
: OF F
MA PS
: ON
PR I N T S P EED AD J US T
= 0 %
PR I N T S P EED AD J US T
= 1 0 %
S E T UP
MA PS [ EN T ]
1
1
3
5
6
3-7