Advertisement
Perform setting to reduce stripes between passes
In case that feeding stripes cannot be resolved even though media correction is performed, make "MAPS
(Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass boundary.
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes
weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes
strong and feeding stripes become less visible.
• The resolutions and passes for which MAPS is enabled are shown in the following table.
• For conditions when MAPS is disabled, the printer operates with MAPS-OFF and print speed settings
disabled (±0%).
• MAPS may not be effective depending on image to be printed.
• Slight color change may be found.
Resolution
(dpi)
540x720
540x1080
720x720
◎ : MAPS can be used when the print speed setting is within a range of ±50%, for both high speed and
standard speed.
○ : At high speed, print speed is within the range of -50% to -1%. At standard speed, MAPS can be used
when the print speed is within a range of ±50%.
△ : MAPS can be used when the print speed setting is within the range of -50% to -1% at standard speed
only.
1
Press the
2
Press the
3
Press the
4
Press
5
Press the
6
Press
• Set Value : OFF, ON
7
Press the
• When you select OFF, proceed to the Step 9.
2
Pass
4 colors
△
○
◎
2
4
8, 16
6
12, 24
4
8, 16
key in LOCAL.
key.
key.
to select [MAPS].
key.
to set ON/OFF.
key.
Resolution
4 colors
(dpi)
△
720x1080
720x1440
F UNC T I ON
S E TUP
S E TUP
S E L EC T
[ 1 ]
MED I A COMP .
[ 1 ]
MA PS
[ 1 ] MA PS
S E TUP
[ 1 ] MA PS
S E TUP
[ 1 ] MA PS
PR I N T S P EED
Pass
○
◎
6
12, 24
8
16, 32
< EN T >
: T Y P E . 1
< e n t >
< e n t >
: OF F
: ON
:
0 %
Advertisement
