Perform Setting To Reduce Stripes Between Passes - MIMAKI SWJ-320 S2 Operation Manual

Perform setting to reduce stripes between passes

In case that feeding stripes cannot be resolved even though media correction
"MAPS (Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass
boundary. (Supported from the firmware ver.2.00)
• The color might change if MAPS is enabled. Check this beforehand.
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes
weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes
strong and feeding stripes become less visible.
• When printing, if you set the printing speed to 0% and more, MAPS becomes invalid. In addition, it
prints at 0% speed. When you use MAPS, set the printing speed to "minus (-)".
Resolution
360x600
540x600
720x600
720x600
720x900
720x900
1
Press the
2
Press the
3
Press
4
Press the
5
Press
• Set Value : OFF, ON
6
Press the
• When you select OFF, proceed to the Step 11.
7
Press
• Set Value : PATTERN1 / PATTERN2
8
Press the
Pass Scan speed
2Pass Normal speed
2Pass Normal speed
2Pass Normal speed
4Pass High speed
3Pass Normal speed
6Pass High speed
key in LOCAL.
key.
to select [MAPS].
key.
to set ON/OFF.
key.
to change print pattern.
• The MAPS effectiveness varies depending on the printed image.
When changing the print pattern, check the effectiveness before using the MAPS function.
key.
( P.2-26)
Resolution Pass
1080x600 2Pass
1080x600 4Pass
1080x900 3Pass
1080x900 6Pass
1080x1200 4Pass
1080x1200 8Pass
F UNC T I ON
S E T UP
S E T UP
F E ED COMP .
S E T UP
MA PS
MA PS
: OF F
MA PS
: ON
MA PS
P A T T ERN : 1
MA PS
P A T T ERN : 1
PR I N T S P EED AD J US T
=
is performed, make
Scan speed
Normal speed
High speed
Normal speed
High speed
Normal speed
High speed
[ EN T ]
[ EN T ]
[ EN T ]
0 %
3-5
1
1
3
5
6