Set The Media Feeding Amount; Setting Feed Correction - MIMAKI JV400-LX Series Operation Manual

Set the media feeding amount

Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor
printing.
• When you have changed the media type, check the pattern and perform adjustment depending on the
status.
• When you have changed the temperature of the heaters, make sure that the [CONSTANT] lamp lights
up and that the preset temperature is reached, and then start the correction.
• When printing with a take-up device, set the media first and then perform media correction.

Setting Feed Correction

A pattern for media correction is printed and a media-feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is obtained in the boundary between the two bands.
1
Set a media. (
2
Press the
3
Press the
4
Press the
5
Check the correction pattern and enter a correction
value.
Enter a correction value in "+": The boundary between the two bands is widened.
Enter a correction value in "-": The boundary between the two bands is narrowed.
Second band
First band
P.2-5)
key in LOCAL.
key.
key to print a correction pattern.
Media advance direction
F E ED COMP .
< EN T >
F E ED COMP .
PR I N T [ EN T ]
* * PR I N T I NG * *
P L E A SE WA I T
F E ED COMP .
= 0
2-23
1
2
4
5
6