Adjustment To Refine Finished Printing; Flow Of Media Feeding Correction - MIMAKI Tx300P-1800 Operation Manual

Chapter 2 Basic Operation

Adjustment to Refine Finished Printing

If lines appear on the printed results, adjust the feed and take-up units as follows and readjust the media feed rate.
• When you have changed the media type, check the pattern and perform adjustment depending on the status.
• When printing with a take-up device, set the media first and then perform media correction.

Flow of media feeding correction

Check that the feed correction
1
setting value is "0".
Make the torque of the tension
2
roller biggest.
Print the correction pattern.
3
Check the pattern and adjust
4
the counter weight of feeding/
take-up tension bar.
If correction by counter weight
5
adjustment is not enough,
adjust the torque.
If correction by counter weight/
6
torque adjustment is not
enough, input the correction
value in the feed correction
setting.
2-34
Referring to "Feed settings"
( P.2-31).
Referring to "Setting the torque limiter (cloth
media)"
( P.2-14).
Referring to "Feed settings"
( P.2-31).
Referring to "How to adjust the weight of feeding/
take-up tension-bar (cloth media)"
( P.2-11).
Referring to "Feeding/ Take-up device"
( P.2-9).
Referring to "Feed settings"
( P.2-31).