Set The Media Feeding; Flow Of Media Feeding Correction - MIMAKI Tx300P-1800B Operation Manual

Chapter 2 Basic Operation

Set the media feeding

Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor printing.
• When you have changed the media type, check the pattern and perform adjustment depending on the status.
• When printing with a take-up device, set the media first and then perform media correction.

Flow of media feeding correction

Perform media feeding correction as below:
Check that the feed correction
1
setting value is "0".
Set the peeling roller to the
2
maximum torque.
Print the correction pattern.
3
Check the pattern and adjust
4
the counter weight of feeding/
take-up tension bar.
If correction by counter weight
5
adjustment is not enough,
adjust the torque.
If correction by counter weight/
6
torque adjustment is not
enough, input the correction
value in the feed correction
setting.
2-26
Referring to "Setting of Media Correction"
( P.2-27).
Referring to "Setting the torque limiter"
( P.2-17).
Referring to "Setting of Media Correction"
( P.2-27).
Referring to "Tension Bar Weight Adjustment"
( P.2-18).
Referring to "Setting the torque limiter"
( P.2-17).
Referring to "Setting of Media Correction"
( P.2-27).