Finisher Fold Position Sensor Failure - Xerox Paser 7400 Service Manual

Finisher Fold Position Sensor Failure

An error was detected with the Fold Position Sensor.
Applicable Status Code:
Code F131:
Fold Position Sensor failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fold Position Sensor
Finisher Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Test the Folding Position Sensor.
Run the Service Diagnostics Bookbinding
Position Sensor test.
Does the sensor function correctly?
2
Check the sensor connection.
Is CN39 connected?
3 Replace the sensor.
Does the error persist?
4 Check all pins on the harness for continuity.
Is the harness conductive?
3-52
Wiring and Plug/Jack References
Options Map 1 Finisher Controller Board
Options Map 8 Finisher Sensor Locator
Options Finisher Controller to Sensors (2/3)
Phaser 7400 Color Printer Options Service Manual
Yes
Replace the
Finisher Control
Board.
Go to Step 3.
Go to Step 4.
Replace the
Finisher Control
Board (page 5-46).
No
Go to Step 2.
Reconnect the
sensor.
Complete
Replace the
harness.