Show Ip Ospf Virtual-Link - Dell Networking 2024 Reference Manual

show ip ospf virtual-link

Use the show ip ospf virtual-link command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all.
Syntax
show ip ospf virtual-link [
area-id — Identifies the OSPF area whose ranges are being displayed.
•
(Range: IP address or decimal from 0–4294967295)
neighbor-id — Identifies the neighbor's router ID. (Range: Valid IP
•
address)
Default Configuration
Show information for all OSPF Virtual Interfaces.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 10 and its neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID............................. 192.168.2.2
Hello Interval................................. 10
Dead Interval.................................. 655555
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... down
Metric......................................... 0
Neighbor State................................. down
Authentication Type............................ MD5
Authentication Key............................. "test123"
1272
OSPF Commands
area-id neighbor-id
]