Syntax
power inline high-power
no power inline high-power
Default Configuration
The default value is disabled.
Command Mode
Interface Configuration.
User Guidelines
The system does not apply high power to the interface until an LLDP-MED
packet is received from the link partner requesting the application of high
power.
power inline limit
Use the power inline limit command to configure the type of power limit.
Use the no form of this command to set the power limit type to the default.
Syntax
power inline limit user-defined
no power inline limit
user-defined
•
value. The range of limit is 3000-32000 milliwatts.
Default Configuration
The default power limit is 32000 milliwatts.
Command Mode
Interface Configuration
1528
Power Over Ethernet Commands
limit
limit —Allows the port to draw up to user-defined configured