Show Fiber-Ports Optical-Transceiver - Dell Networking 2024 Reference Manual

console#show copper-ports tdr
Port Result
---- --------
1/0/1 OK
1/0/2 Short
1/0/3 Test has not been performed
1/0/4 Open
1/0/5 Fiber

show fiber-ports optical-transceiver

Use the show fiber-ports optical-transceiver command in Privileged EXEC
mode to display the optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [
interface — A valid fiber port.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The show fiber ports command is applicable to all fiber ports, including SFP,
SFP+, and XFP ports. It will display an error if executed against a copper port
or passive or active direct attach cables.
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port Temp
----------- ------
1/0/3
1/0/4
1/0/1
1522
PHY Diagnostics Commands
Length [meters]
---------------
50
128
-
Voltage Current
------- -------
w OK
OK OK
Copper
Date
---------------
13:32:00 23 July 2004
13:32:08 23 July 2004
-
interface
]
Output Input
Power Power
------ -----
E OK
OK OK
TX LOS
Fault
----- ---
OK OK OK
OK E OK