Switch Renumber - Dell Networking 2024 Reference Manual

Default Configuration
The default configuration is to allow the software to automatically select a
standby unit.
Command Mode
Stack Global Configuration
User Guidelines
No specific guidelines.
Examples
console(config)#stack
console(config-stack)#standby 2

switch renumber

Use the switch renumber command in Global Configuration mode to change
the identifier for a switch in the stack. Upon execution, the switch is
configured with the configuration information for the new switch, if any is
available. The old switch configuration information is retained; however, the
old switch will be
Syntax
oldunit
switch renumber
oldunit — The current switch identifier. (Range: 1–6)
•
newunit — The updated value of the switch identifier. (Range: 1–6)
•
Command Mode
Global Configuration mode
User Guidelines
This command is executed on the Management Switch.
operationally detached
newunit
.
System Management Commands
1735