Dell Networking 2024 Reference Manual page 1247

Default Passive
Setting
Maximum Paths
Default Metric
Stub Router
Configuration
Stub Router
Startup Time
Summary LSA
Metric Override
Default Route
Advertise
Always
Metric
Metric Type
Number of Active
Areas
ABR Status
ASBR Status
Stub Router Status One of Active or Active.
Stub Router
Reason
Stub Router Time
Remaining
When enabled, OSPF interfaces are passive by default.
Shows the maximum number of paths that OSPF can report for
a given destination.
Default metric for redistributed routes.
One of Always, Startup, or None.
Configured value in seconds. This row is only listed if OSPF is
configured to be a stub router at startup.
met
One of Enabled (
sent in summary LSAs when in stub router mode.
When enabled, OSPF originates a type 5 LSA advertising a
default route.
When this option is configured, OSPF only originates a default
route when the router has learned a default route from another
source.
Shows the metric for the advertised default routes. If the metric
is not configured, this field is not configured.
Shows whether the metric for the default route is advertised as
External Type 1 or External Type 2.
The number of OSPF areas to which the router is attached on
interfaces that are up.
Shows whether the router is an OSPF Area Border Router.
Indicates whether the router is an autonomous system border
router. Router automatically becomes an ASBR when it is
configured to redistribute routes learned from another protocol.
The possible values for the ASBR status is enabled (if the router
is configured to redistribute routes learned by other protocols) or
disabled (if the router is not configured for the same).
One of Configured, Startup, or Resource Limitation. This row
is only listed if stub router is active.
The remaining time until OSPF exits stub router mode. This
row is only listed if OSPF is in startup stub router mode.
), Disabled, where
OSPF Commands
met
is the metric to be
1247