Show Checkpoint Statistics - Dell Networking 2024 Reference Manual

Line SSH.......................... Enable
Line Telnet....................... Enable
===motd=====

show checkpoint statistics

Use the show checkpoint statistics command to display the statistics for the
checkpointing process.
Syntax
show checkpoint statistics
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
When nonstop forwarding is enabled on a stack, the stack's management unit
checkpoints operational data to the backup unit. If the backup unit takes over
as the management unit, the control plane on the new management unit uses
the checkpointed data when initializing its state. Checkpoint statistics track
the amount of data checkpointed from the management unit to the backup
unit.
Example
console#show checkpoint statistics
Messages Checkpointed.....................6708
Bytes Checkpointed........................894305
Time Since Counters Cleared...............3d 01:05:09
Checkpoint Message Rate...................0.025 msg/sec
Last 10-second Message Rate...............0 msg/sec
Highest 10-second Message Rate............8 msg/sec
1697
System Management Commands