Logging Audit - Dell Networking 2024 Reference Manual

PRI
Timestamp
Host IP Address
Stack ID
Component Name
Thread ID
File Name
Line Number
Sequence Number
Message
Example
The following example places the designated server in logging configuration
mode.
console(config)#logging 192.168.15.1

logging audit

Use the logging audit command to enable switch auditing. Use the no form
of the command to disable switch auditing.
Syntax
logging audit
no logging audit
1654
Syslog Commands
This consists of the facility code (see RFC 3164) multiplied by
8 and added to the severity. See below for more information on
severity.
The system up time. For systems that use SNTP , this is UTC.
When time zones are enabled, local time will be used.
The IP address of the local system.
The assigned stack ID. 1 is used for systems without stacking
capability. The top of stack is used to collect messages for the
entire stack.
Component name for the logging component. Components
must use the new APIs in order to enable identification of the
logging component. Component UNKN is substituted for
components that do not use the new logging APIs.
The thread ID of the logging component.
The name of the file containing the invoking macro.
The line number which contains the invoking macro.
The message sequence number for this stack component.
Sequence numbers may be skipped because of filtering but are
always monotonically increasing on a per stack member basis.
An informative message regarding the event.