Max-Metric Router-Lsa - Dell Networking 2024 Reference Manual

Syntax
log-adjacency-changes [detail]
no log-adjacency-changes [detail]
• detail—(Optional) When this keyword is specified, all adjacency state
changes are logged. Otherwise, OSPF only logs transitions to FULL state
and when a backwards transition occurs.
Default Configuration
Adjacency changes are not logged by default.
Command Mode
OSPFv2 Router Configuration mode
User Guidelines
State changes are logged with INFORMATIONAL severity.

max-metric router-lsa

Use the max-metric router-lsa command in router OSPF Global
Configuration mode to configure OSPF to enable stub router mode.
To disable stub router mode, use the no max-metric router-lsa command in
OSPFv2 Global Router Configuration mode.
Syntax
max-metric router-lsa [on-startup
no max-metric router-lsa [on-startup] [summary-lsa]
• on-startup—(Optional) OSPF starts in stub router mode after a reboot.
seconds —(Required if on-startup) The number of seconds that OSPF
•
remains in stub router mode after a reboot. The range is 5 to 86,400
seconds. There is no default value.
• summary-lsa—(Optional) Set the metric in type 3 and 4 summary LSAs to
LsInfinity (0xFFFFFF).
metric —(Optional) Metric to send in summary LSAs when in stub router
•
mode. Range is 1 to 16,777,215. Default is 16,711,680 (0xFF0000).
1234
OSPF Commands
seconds
] [summary-lsa {
metric
}]