Configuring A Group Of Radius Servers; Figure 303 Objects > Aaa Server > Radius > Default; Table 156 Objects > Aaa Server > Radius > Default - ZyXEL Communications ZyWALL 1050 User Manual

ZyWALL 1050 User's Guide
Figure 303 Objects > AAA Server > RADIUS > Default
The following table describes the labels in this screen.
Table 156 Objects > AAA Server > RADIUS > Default
LABEL
Host
Authentication
Port
Key
Timeout
Apply
Reset

31.6 Configuring a Group of RADIUS Servers

You can configure a group of RADIUS servers in the RADIUS > Group screen. This is useful
if you have more than one authentication server for user authentication in a network.
1 Click Objects > AAA Server > RADIUS > Group to display the screen.
462
DESCRIPTION
Enter the IP address (in dotted decimal notation) or the domain name (up to 63
alphanumeric characters) of a RADIUS server.
The default port of the RADIUS server for authentication is 1812.
You need not change this value unless your network administrator instructs you to do
so with additional information.
Enter a password (up to 15 alphanumeric characters) as the key to be shared
between the external authentication server and the ZyWALL.
The key is not sent over the network. This key must be the same on the external
authentication server and the ZyWALL.
Specify the timeout period (between 1 and 300 seconds) before the ZyWALL
disconnects from the RADIUS server. In this case, user authentication fails.
Search timeout occurs when either the user information is not in the RADIUS server
or the RADIUS server is down.
Click Apply to save the changes.
Click Reset to start configuring this screen again.
Chapter 31 AAA Server