Printer Maintenance Mode - Muratec MFX-1330 Field Engineering Manual

3.8 Printer maintenance mode

In case of followings, use this mode.
• When you have replaced the Fuser unit and/or Transfer roller.
• When "Please Call Service" message appear in the LCD, access this mode to determine the cause of the
"Please Call Service" error message.
When you replace the Fuser unit or Transfer roller, you must set the count of replacement
manually
To access the printer maintenance mode:
1. Press MENU, *, 0, 6.
The mode is contained within two main menu levels.
Set Replace Counter
/ /Enter
Service Call
/ /Enter
2. Select "Set Replace Counter" and then press ENTER.
3. The LCD shows:
Replace Fuser
/ /Enter
4. If you've replaced the fuser unit, press ENTER and then skip to step 7.
5. If you've replaced the transfer roller, press
The LCD shows:
Replace Transfer
/ /Enter
6. Press ENTER. The machine goes back to standby mode.
When "Please Call Service" message is displayed on the LCD
To access the printer maintenance modes for determine the cause of the "Please Call Service" error
message.
1. Press MENU, *, 0, 6.
The mode is contained within two main menu levels.
Set Replace Counter
/ /Enter
Service Call
/ /Enter
2. Press or until "Service Call" appears in the LCD and then press ENTER.
3. The kind of printer error will be displayed. If happens two or more troubles, the number of troubles is
displayed on the right upper of the LCD. For example, when "Heater error" and "Drum Fuse Error" has
occurred, the LCD shows 2.
Service Call
Heater Error
4. Press or to show the other printer error.
5. Press RESET to exit this mode.
Note: See "4.15.2 Please Call Service," pages 4-23 to 4-25 for the printer error messages and an
explanation of each are outlined.
or
:2 How many troubles
3-97
.