Muratec MFX-1330 Field Engineering Manual page 82

Memory Switch 12 - Transmission
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Changing the date format of
the transmitted TTI
0: No
1: Yes
4 1 TTI transmit
0: No
1: Yes
(Note: Turning TTI
transmission off may violate
local or federal regulations.)
3 0 ECM response time
0: 3 sec
1: 4.8 sec
2 0 ECM error retransmit time
0: 200 ms
1: 400 ms
1 0 Interval between DIS and DCS
0 0
Switch 1
Switch 0
Memory Switch 13 - Transmission
Initial
Switch
Setting
7 0 ANSam detection
0: Yes
1: No
6 0 V.34 transmission
0: Yes
1: No
5 0 CSI/TSI/CIG transmit
0: Yes
1: No
4 0 ECM mode
0: On
1: Off
3 0 Retransmit automatically
when receiving RTN/PIN
signals
0: Yes
1: No
2 1 Factory use only
1 0 Factory use only
0 0 Factory use only
Adjust
When set to "1", the machine changes the date
format of the transmitted TTI from MM:DD:YY, or
vice versa.
When set at "0", transmission of the TTI is
disabled. The TTI includes the followings:
• Sender name
• Sender's fax number
• Data & time, and number of pages
To set the individually transmission of them, see
Memory SW 016.
The time limit to receive the response signal for the
ECM post message.
The time limit before the ECM error is
retransmitted.
0 ms 500 ms 1000 ms 1500 ms
0 0 1
0 1 0
Adjust
During the V8 handshake, if some noise disturbs
the handshake and an error occurs, set to "1".
Individual setting for V.34 transmission.
When set at "1", transmission of the CSI, TSI and
CIG signals are disabled.
Determines ECM mode. ECM mode reduces
document memory and may lengthen transmission
and reception times.
When set to "1", retransmission disables
automatically if receiving RTN/PIN signals.
3-54
Usage/Comments
1
1
Usage/Comments