4. Select the paper size to test.
Paper Size
5. Press
until the desired size is displayed.
or
6. Press ENTER.
Pattern
** Printing **
The selected pattern will be printed continuously.
Note: Press STOP to stop printing.
7. To select another pattern, repeat the steps 1 to 6.
3.10.3 Feeder test
The feeder test discharges all documents in the automatic document feeder at a constant speed and displays
the document total in the LCD.
1. Load test documents into the automatic document feeder.
2. Press MENU, *, 0, 9,
Feeder Test
3. Press START to start the feeder test.
4. Press STOP to exit the test mode.
3.10.4 Port Status
This test mode is not applicable to field service of this machine.
3.10.5 Set Background Level
The background level is an established threshold used to help measure the reflective ability of a scanned
document. This threshold can change if the scanner lamp, CCD, or the ballast is replaced; therefore this
mode should be used to reset the threshold when these items are changed.
The Set Background Level mode allows the level to be set without erasing memory contents.
Note: The background seal at the inside of the scanner cover should be cleaned prior to setting the
background level to ensure an accurate reading.
1. Press MENU, *, 0, 9,
Set Background Level
:A4
/ /Enter
B
twice, then press ENTER.
/ /Enter
four times, then press ENTER.
3-101