Muratec MFX-1330 Field Engineering Manual page 178

What you see on the LCD
Document Stored
Drum Near End
Enter No. (0-32)
Enter No. (000-255)
Enter Reduce/Enlarge
Enter Scan Size
Feeder In Use
Hang Up Phone
In Relay Box
or
In Secure Box
Invalid I.D. Code
Invalid Number
Invalid Passcode
Line Busy
Macro In Use
Memory Overflow
Start Or Cancel
Memory Overflow
Press Stop
Mirror Carriage Error
Mirror Locked
What it means/What to do
You tried to erase a batch box which contains at least one document. Erase
the document(s), then try again.
Your drum will need to be replaced soon.
You tried to enter a call group number greater than 32. Your machine can
maintain 32 call groups, numbered 1-32 (call group 0 covers all the groups).
Determine the correct call group identifier number and enter it, instead.
If the optional NIC (network interface card) is attached to your machine, and
you tried to enter a TCP/IP address greater than 255.
Enter the correct TCP/IP address.
You tried to copy your document on the paper other than A4, A5 or F4 sized
paper using the bypass tray, or the calculated reduction or enlargement ratio
is out of the acceptable range (50 – 200 %) when the copy reduction or
enlargement ratio is set to "Auto".
Enter the reduction or enlargement ratio manually although a part of the
image might be lacked, or change the paper for copying.
When you using the Document glass (Flatbed scanner), you must manually
enter the scan size of your document.
Press DOCUMENT SIZE to choose the size.
The command you're trying to enter requires the use of the ADF, which is
already in use.
Wait for the machine to stop using the ADF, then try again.
The optional handset is off-hook.
Hang it up, making sure the upper part of the handset presses down on the
"hook" button.
You tried to store a document into the F-code box which is set to be a relay
box or security box.
Select the F-code box which is set to be a bulletin box.
The F-Code box I.D. code you entered isn't valid.
Try re-entering your F-Code box I.D. code.
You pressed a key which has no function during the current operation.
The protection passcode you entered isn't valid.
Repeat the operation, entering the correct protection passcode.
You tried to erase a document which someone is polling from your machine.
Wait for the fax to complete the polling operation, then try again.
You tried to change the function for a Soft key, but that Soft key has been
programmed in a Macro key. You cannot change the Soft key function until
erase the Macro key that contains the Soft key you want to change. Erase
the Macro key, then try again.
During transmission (or copying), you tried to enter more pages into
memory than your fax could store.
Press START to tell your fax to keep as many pages in memory as possible,
or press CANCEL to delete from memory all pages stored during this
operation (but not previous operations).
In PC printing, the machine received data more than it can fit in memory.
Press to cancel the printing job. Either delete unnecessary documents,
STOP
retry after more memory becomes available, or split the printing into more
than one operation.
The mirror carriage of your machine has become inoperable.
The transport mode is not turned off.
Turn off the transport mode.
4-16