Printer Section; Clutch (Mg) - Muratec MFX-1330 Field Engineering Manual

5.2.4 PRINTER SECTION

SOLENOID
1) Remove the Cover option.
2) Remove the Cover shield.
3) Remove the Cover back.
4) Remove the Bracket solenoid mounting screw, and then remove the Bracket solenoid.
5) Cut the Cable tie, and disconnect the connector.
6) Remove the Solenoid mounting screw, and then remove the SOLENOID.

CLUTCH (MG)

1) Remove the Cover option.
2) Remove the Cover shield.
3) Remove the Cover back.
4) Remove two plastic rings.
5) Disconnect the connector of Clutch (MG), and then remove the CLUTCH (MG).
( See page 5-20)
H H H H H H H H H H H H H H H H H H H H H H H H H H H H
( See page 5-20)
H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H
( See page 5-32)
H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H
Cable tie
( See page 5-20)
H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H
( See page 5-20)
H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H
( See page 5-32)
H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H H
Clutch(MG)
5-42 5-42
Solenoid
Bracket solenoid
Clutch(MG)