Muratec MFX-1330 Field Engineering Manual page 180

What you see on the LCD
Please Wait
Polling In Use
Printer In Use
Protect Doc. Stored
Pull Blue Rod and
Close Front Cover
Remove Bypass Paper
Open&Close Front Cover Pull up he flapper release lever and pull the paper out of the machine. Then
Ration must be 100%
Replace Drum Soon
Replace Drum Unit
Printer Not Usable
Scanner In Use
SecurityRx is Off
Select Paper Size
Sub-address In Use
Toner Almost Empty
Toner Empty
Printer Not Usable
Too Many Characters
What it means/What to do
Your fax machine's printer is either warming up or busy.
Please wait until the fax is finished printing and then re-try your command or
operation.
You tried to store the polling document in your fax machine, where one
already had been stored.
Wait for the fax to complete the regular polling operation or delete the stored
document, then try again.
The command you're trying to enter requires the use of the printer, which is
already in use.
Wait for the fax to finish printing, then try again.
A received document was in your fax's memory when you tried to turn off the
security reception passcode.
Print the received document from your fax's memory, then retry the desired
operation.
The drum charge wire requires cleaning.
Open the front cover, then pull the blue rod to clean the charge wire.
A paper is not properly fed into the machine through the bypass tray.
open and close the front cover to reset the printer.
You cannot set the magnification ratio in Negative/Positive copy.
Set the magnification ratio to 100 % to use the Negative/Positive copy.
Your machine can print about 500 more sheets, but your drum will need to
bereplaced soon. Replace it.
Your drum cartridge doesn't work.
Your machine cannot print until it is replaced with a new drum cartridge.
Replace it.
The command you're trying to enter requires the use of the scanner, which
is already in use.
Wait for the fax to complete the scan, then re-try the desired command.
You tried to turn the security reception on using a Soft key which is assigned
to set the security reception to on or off, but security reception setting has
not set to on.
To turn on or off the security reception using a Soft key, first set the security
reception setting to on.
You tried to make a copy in the following conditions:
•Paper size selection is set to "Auto".
•The bypass tray has the paper other than Letter, Legal, Half-letter.
•Paper cassette(s) runs out of paper.
Press to select your desired paper.
PAPER SIZE
You tried to enter a sub-address identical to one already being used in
another F-Code box.
Enter a different sub-address.
Your machine is almost out of toner. About 50 more sheets can be printed.
Your toner cartridge is empty.
Replace the toner cartridge. Your machine cannot print until it is replaced
with a new toner cartridge.
You attempted to enter too many numbers or other characters in the current
operation.
Press CANCEL to delete the extra characters, then try again. You may wish
to review the operation's appropriate instructions.
4-18