Configuring Switch Ethernet Ports; Switch Ethernet Port Commands - Avaya G350 Administration

Configuring Ethernet ports

Configuring switch Ethernet ports

Configuring switch Ethernet ports
For basic configuration of a switch Ethernet port, use the commands listed below. You can also configure
the following features on a switch Ethernet port:
•
Advanced switching features, including VLANs. For more information, see
"Configuring advanced
•
VoIP queuing. To configure VoIP queuing on a switch port, configure a VLAN for the port. Then
configure VoIP queuing on the VLAN. For more information about VoIP queuing, see
Configuring QoS parameters
•
Access control policy lists and QoS policy lists. To configure policy lists on a switch port,
configure a VLAN for the port. Then configure policy on the VLAN. For more information on
policy lists, see
•
SNMP Link Up and Link Down traps. For more information, see
page 102.

Switch Ethernet port commands

Use the following commands for basic configuration of switch Ethernet ports. For more information
about these commands, see Avaya G350 Media Gateway CLI Reference, 555-245-202.
•
Use the
advertisement for the specified port when performing auto-negotiation. This command is only
applicable to the Gigabit Ethernet port.
•
Use the
•
Use the
port or range of ports.You can configure Ethernet and Fast Ethernet interfaces to either full duplex
or half duplex. The duplex status of a port in auto-negotiation mode is determined by
auto-negotiation. When auto-negotiation is enabled, an error message is generated if you attempt
to set the transmission type of auto-negotiation Fast Ethernet ports to half-duplex or full-duplex
mode.
•
Use the
assumed to be in.
•
Use the
•
Use the
switching bus. Packets traveling through a port set at normal priority should be served only after
packets traveling through a port set at high priority are served.
•
Use the
•
Use the
specified port. This command applies to Fast Ethernet or Gigabit Ethernet ports. When
negotiation is enabled, the speed and duplex of the Fast Ethernet ports are determined by
auto-negotiation. If negotiation is disabled, the user can set the speed and duplex of the Fast
Ethernet ports.
58
switching".
on page 63.
Chapter 17, "Configuring
set port auto-negotiation-flowcontrol-advertisement
command to disable a port or range of ports.
set port disable
command to configure the duplex type of an Ethernet or Fast Ethernet
set port duplex
set port edge admin state
command to enable a port or a range of ports.
set port enable
command to set the priority level of a port or range of ports on the
set port level
command to configure a name for a port.
set port name
command to enable or disable the link negotiation protocol on the
set port negotiation
policy".
command to set the administrative state the specified port is
Administration of the Avaya G350 Media Gateway
Chapter 13,
Configuring SNMP traps
command to set the flowcontrol
June 2004
on