Configuring policy
Displaying and testing policy lists
•
In access control list rule context:
—
show composite-operation
assigned to the current rule
—
show ip-rule
•
In QoS list context:
—
show composite-operation
the list
—
show dscp-table
—
show ip-rule
—
show list
•
In QoS list rule context:
—
show composite-operation
assigned to the current rule
—
show dscp-table
—
show ip-rule
•
In QoS list DSCP table context:
—
show dscp-table
•
In QoS list composite operation context:
—
show composite-operation
operation
Simulating packets
Use the
ip simulate
effect of the policy list on a simulated IP packet in the interface. You must specify the number of a policy
list, the direction of the packet (in or out), and a source and destination IP address. You may also specify
other parameters. For a full list of parameters, see Avaya™ G350 Media Gateway CLI Reference,
555-245-202.
The following command simulates the effect of applying QoS list number 401 to a packet entering the
G350 through interface VLAN 2:
G350-001(if:Vlan 2)# ip simulate 401 in CoS1 dscp46 10.1.1.1
tcp 1182 20
The simulated packet has the following properties:
•
CoS priority is 1
•
DSCP is 46
•
source IP address is 10.1.1.1.
•
destination IP address is 10.2.2.2.
•
IP protocol is TCP
•
source TCP port is 1182
•
destination TCP port is 20
174
— displays the parameters of the composite operation
— displays the parameters of the current rule
— displays a list of all composite operations configured for
— displays the current list's DSCP table
— displays a list of all rules configured for the list
— displays the parameters of the current list, including its rules
— displays the parameters of the composite operation
— displays the current list's DSCP table
— displays the parameters of the current rule
— displays the parameters of the current DSCP table entry
— displays the parameters of the current composite
command in the context of an interface to test a policy list. The command tests the
Administration of the Avaya G350 Media Gateway
10.2.2.2
June 2004