Spanning Tree Cli Commands; Spanning Tree Configuration Examples - Avaya G350 Administration

Configuring advanced switching
Configuring spanning tree
•
Point-to-point Link ports — This port type applies only to ports interconnecting RSTP compliant
switches and is used to define whether the devices are interconnected using shared Ethernet
segment or point-to-point Ethernet link. RSTP convergence is faster when switches are connected
using point-to-point links. The default setting for all ports – automatic detection of point-to-point
link – is sufficient for most networks.

Spanning tree CLI commands

Use the following commands to configure spanning tree. For more information about these commands,
see Avaya G350 Media Gateway CLI Reference, 555-245-202.
•
Use the
switch ports.
•
Use the
path cost used by this bridge.
•
Use the
•
Use the
state of a port to the forwarding state.
•
Use the
configuration BPDUs by the root.
•
Use the
before it is discarded.
•
Use the
•
Use the
tree in order to limit the maximum number of BPDUs transmitted during a hello-time period.
•
Use the
•
Use the

Spanning tree configuration examples

This section provides spanning tree configuration examples.
The following example enables spanning tree on a port:
G350-003(super)# set port spantree enable 6/8
port 6/8 was enabled on spantree
The following example disables spanning tree on a port:
G350-003(super)# set port spantree disable 6/8
port 6/8 was disabled on spantree
The following example configures the version of the spanning tree default path cost used by this bridge:
G350-003(super)# set spantree default-path-cost common-spanning-tree
Spanning tree default path costs is set to common spanning tree.
120
command to enable or disable the spanning tree mode for specific
set port spantree
set spantree default-path-cost
set spantree enable/disable
set spantree forward-delay
command to specify the time interval between the generation of
set spantree hello-time
command to specify the time to keep an information message
set spantree max-age
set spantree priority command to set the bridge priority for STP.
set spantree tx-hold-count
command to set the version of the spanning tree protocol.
set spantree version
show spantree command to display spanning-tree information.
command to set the version of the spanning tree default
command to enable or disable the spanning tree algorithm.
command to specify the time used when transferring the
command to set the value in packets used by the spanning
Administration of the Avaya G350 Media Gateway
June 2004