Configuring The Avaya Mm342 Usp Wan Media Module - Avaya G350 Administration

E1/T1 default settings
Table 5, E1/T1 default settings,
Table 5: E1/T1 default settings
Function
DS mode
E1 framing
T1 framing
E1 linecode
T1 linecode
Clock source
T1 cable length
Speed
Configuring the Avaya MM342 USP WAN
media module
For a list of the USP default settings, see
To configure USP ports:
1
Use the
the media module, the port number, and optionally the IP interface number. For example:
— interface Serial 4/1
number 1.
— interface Serial 5/1.2
port number 1, with IP interface number 2.
You do not need to specify an IP interface number for the first serial interface that you define on a
port. For each additional serial interface that you define on the port, use a different IP interface
number.
2
Use the following commands to change the idle characters, transmitter delay, encoding type, and
bandwidth parameters from their default settings:
— idle characters {flags|marks}
—
transmitter-delay {number}
NOTE:
The
connected directly to the G350, or the router on the WAN have a receive buffer that is not
large enough to hold the traffic sent by the G350. In this case, configure
on the DCE equipment or the remote router in order to preserve the high performance that
you had when
— nrzi-encoding
— bandwidth {kilobits}
Administration of the Avaya G350 Media Gateway
June 2004
on page 77 shows the default settings for E1/T1 WAN lines on the G350:
USP default settings
command to enter the context of the interface. Specify the slot number of
interface Serial
enters a serial interface on the media module in slot number 4, on port
enters a serial interface on the media module in slot number 5, on
command is usually used when the DCE equipment that is
transmitter-delay
transmitter-delay
Default setting
T1
CRC4
SF
HDB3
AMI
Line
Long, Gain 26.0 db
56 kbps
on page 78.
was configured to 0 on the G350.
Configuring a WAN
Initial WAN configuration
transmitter-delay
77