Configuring The Wan Ethernet Port; Wan Ethernet Port Traffic Shaping - Avaya G350 Administration

•
Use the
number of the port, to manage the connection type of the port. Use one of the following
arguments with this command:
— force-true
—
force-false
—
auto
•
Use the
auto-negotiation mode, the port's speed is determined by auto-negotiation. An error message is
generated if you attempt to set the speed when auto-negotiation is enabled

Configuring the WAN Ethernet port

For basic configuration of the WAN Ethernet port:
1
Use the
2
Perform basic configuration of the interface. For more information, see
page 134.
3
Use the Ethernet WAN port configuration commands in the context of the port interface. See
WAN Ethernet port commands
You can also configure the following features on the WAN Ethernet port:
•
Primary Management Interface (PMI). For more information, see
Management Interface (PMI)
•
Advanced router features. For more information, see
•
VoIP queuing. For more information, see
•
Access control policy lists and QoS policy lists. For more information, see
"Configuring
•
SNMP Link Up and Link Down traps. For more information, see
page 102.

WAN Ethernet port traffic shaping

You can use traffic shaping to determine the data transfer rate on the WAN Ethernet port. To set traffic
shaping, use the
with the configured bandwidth. If you change the traffic shape rate, this automatically changes the
bandwidth. Similarly, if you change the bandwidth, this automatically changes the traffic shape rate.
NOTE:
The traffic shape rate is determined in bits. The bandwidth is determined in kilobytes.
To disable traffic shaping, use the
For information on traffic shaping in general, see
Administration of the Avaya G350 Media Gateway
June 2004
set port point-to-point admin status
— the port is treated as if it were connected point-to-point
— the port is treated as if it were connected to shared media
— the G350 tries to automatically detect the connection type of the port
command to configure the speed of a port or range of ports. In
set port speed
interface FastEthernet 10/2
on page 60.
on page 40.
policy".
command in the interface context. Traffic shaping works in tandem
traffic-shape rate
form of the
no
Configuring the WAN Ethernet port
command, followed by the module and port
command to enter the context of the port interface.
Chapter 16, "Configuring the
Configuring QoS parameters
command.
traffic-shape rate
Configuring QoS parameters
Configuring Ethernet ports
Configuring interfaces
Configuring the Primary
router".
on page 63.
Chapter 17,
Configuring SNMP traps on
on page 63.
on
59