Programming Connections for the 1600 DSL Module
The programming of the 1600 DSL module is
separate from the programming of the PARTNER
ACS. You can program the 1600 DSL module either
locally or remotely.
To locally program the module, connect a cable from
a PC's serial port to the Console port on the module.
For Release 4.0 or later, you can set up the module
for remote programming by following these steps
(see
Figure
2-23):
1. Connect a cable from an extension port on the
system to the Line jack on an external modem.
The modem should have the following
parameters:
14.4 kbps or greater
Auto-Answer is enabled
DTR override is enabled
Echo commands are Suppressed
Result and Error codes are Suppressed
2. Connect a cable from the serial port on the
modem to a null modem.
3. Connect a cable from the null modem to the
Console port on the 1600 DSL module.
Initial Configuration of the 1600 DSL Module
Beginning with Release 5.0 or later, remote administration of the 1600 DSL module is available
through the PARTNER ACS R6.0 PC Administration software. You must have the following:
Release 5.0 or later software on the 1600 DSL module
Release 5.0 or later software version of PARTNER ACS
PARTNER ACS R6.0 PC Administration software
For more information, see the PARTNER
2
PARTNER ACS
Figure 2-23. Remote Programming
2
®
ACS R6.0 PC Administration Getting Started.
Tip/Ring
Extension Port
External Modem
1600 DSL Module
Console Port
Null Modem
Setup
The 1600 DSL Module
Installation
2-25