set dhcp
For information about...
set dhcp exclude
clear dhcp exclude
set dhcp ping
clear dhcp ping
show dhcp binding
clear dhcp binding
show dhcp server statistics
clear dhcp server statistics
set dhcp
Use this command to enable or disable the DHCP server functionality on the Enterasys C3.
Syntax
set dhcp {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read-write.
Example
This example enables DHCP server functionality.
C3(rw)->set dhcp enable
set dhcp bootp
Use this command to enable or disable automatic address allocation for BOOTP clients. By
default, address allocation for BOOTP clients is disabled. Refer to RFC 1534, "Interoperation
Between DHCP and BOOTP," for more information.
Syntax
set dhcp bootp {enable | disable}
Parameters
enable | disable
22-4 DHCP Server Configuration
Enables or disables DHCP server functionality. By default, DHCP server is
disabled.
Enables or disables address allocation for BOOTP clients.
Refer to page...
22-7
22-7
22-8
22-8
22-9
22-9
22-10
22-11