Interface Configuration Commands; Purpose; Commands; Ipv6 Ospf Enable - Enterasys C3G124-24 Configuration Manual

Interface Configuration Commands

Interface Configuration Commands

Purpose

These commands can be used to configure OSPF v3 routing interface parameters.

Commands

For information about...

ipv6 ospf enable

ipv6 ospf areaid
ipv6 ospf cost
ipv6 ospf dead-interval
ipv6 ospf hello-interval
ipv6 ospf mtu-ignore
ipv6 ospf network
ipv6 ospf priority
ipv6 ospf retransmit-interval
ipv6 ospf transmit-delay
ipv6 ospf enable
This command enables OSPFv3 on a router interface or a loopback interface.
Syntax
ipv6 ospf enable
no ipv6 ospf enable
Parameters
None.
Defaults
OSPFv3 is disabled by default.
Mode
Router interface configuration: C3(su)->router(Config-if(Vlan 1))#
Usage
Use this command to enable OSPFv3 on a router VLAN interface or on a loopback interface. Use
the no form of this command to disable OSPFv3 on an interface.
31-22 OSPFv3 Configuration
Note: In order for OSPFv3 to run on an interface, IPv6 must be explicitly enabled on the interface
using the ipv6 enable command.
Refer to page...
31-22
31-23
31-23
31-24
31-25
31-25
31-26
31-27
31-27
31-28