Clear Arpinspection Vlan - Enterasys C3G124-24 Configuration Manual

clear arpinspection vlan

Parameters
src-mac
dst-mac
ip
Defaults
All parameters are optional, but at least one parameter must be specified.
Mode
Switch command, read-write.
Usage
This command removes previously configured additional validation of ARP packets by DAI,
beyond the basic validation that the ARP packet's sender MAC address and sender IP address
match an entry in the DHCP snooping bindings database.
Use the show arpinspection vlan command to display the current status of the additional
validation rules.
Example
This example removes all 3 additional validation conditions.
C3(su)->clear arpinspection validate src-mac dst-mac ip
clear arpinspection vlan
Use this command to disable dynamic ARP inspection on one or more VLANs or to disable
logging of invalid ARP packets on one or more VLANs.
Syntax
clear arpinspection vlan vlan-range [logging]
Parameters
vlan-range
logging
Defaults
If logging is enabled for the specified VLAN but logging is not entered with this command,
logging will remain enabled.
Mode
Switch command, read-write.
23-26 DHCP Snooping and Dynamic ARP Inspection
Clear, or remove, the verification that the sender MAC address equals
the source MAC address in the Ethernet header.
Clear, or remove, the verification that the target MAC address equals
the destination MAC address in the Ethernet header.
Clear, or remove, checking the IP address and dropping ARP packets
with an invalid address.
Specifies the VLAN or range of VLANs on which to disable dynamic
ARP inspection.
(Optional) Disable logging of invalid ARP packets for the specified
VLANs.