ip dvmrp
See also show ip mroute on page 27-47, which can be used to display the IP multicast routing
table.
ip dvmrp
Use this command to enable the DVMRP process. The no form of this command disables the
DVMRP process:
Syntax
ip dvmrp
no ip dvmrp
Parameters
None.
Defaults
None.
Mode
Global configuration: C3(su)->router(Config)#
Example
This example shows how to enable the DVMRP process:
C3(su)->router(Config)#ip dvmrp
ip dvmrp enable
Use this command to enable DVMRP on an interface. The no form of this command disables
DVMRP on an interface:
Syntax
ip dvmrp enable
no ip dvmrp enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to enable DVMRP on the VLAN 1 interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip dvmrp enable
27-26 IPv4 Advanced Routing Protocol Configuration
(su)->router(Config-if(Vlan 1))#