Example
This example shows how to allow Rapid Spanning Tree edge ports to transmit topology change
traps:
C3(rw)->set spantree tctrapsuppress disable
clear spantree tctrapsuppress
Use this command to clear the status of topology change trap suppression on Rapid Spanning Tree
edge ports to the default state of enabled (edge port topology changes do not generate traps).
Syntax
clear spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear topology change trap suppression setting:
C3(rw)->clear spantree tctrapsuppress
set spantree protomigration
Use this command to reset the protocol state migration machine for one or more Spanning Tree
ports. When operating in RSTP mode, this forces a port to transmit MSTP BPDUs.
Syntax
set spantree protomigration <port-string>
Parameters
port-string
Defaults
None.
Mode
Switch command, read-write.
Reset the protocol state migration machine for specific port(s). For a
detailed description of possible port-string values, refer to
Syntax Used in the
CLI" on page 11-1.
clear spantree tctrapsuppress
"Port String
Enterasys C3 Configuration Guide 13-25