Arp; Show Ip Arp Output Details - Enterasys C3G124-24 Configuration Manual

Example
This example shows how to use the show ip arp command:
C3(su)->router#show ip arp
Protocol
------------------------------------------------------------------------------
Internet
Internet
Internet
C3(su)->router#show ip arp 134.141.235.165
Protocol
------------------------------------------------------------------------------
Internet
C3(su)->router#show ip arp vlan 2
Protocol
------------------------------------------------------------------------------
Internet
Table 25-2
Table 25-2 show ip arp Output Details
Output Field
Protocol
Address
Age (min)
Hardware Addr
Interface

arp

Use this command to add or remove permanent (static) ARP table entries. A multicast MAC
address can be used in a static ARP entry. The no form of this command removes the specified
permanent ARP entry:
Syntax
arp ip-address mac-address
no arp ip-address
Parameters
ip-address
mac-address
Address
134.141.235.251
134.141.235.165
134.141.235.167
Address
134.141.235.165
Address
134.141.235.251
provides an explanation of the command output.
What It Displays...
ARP entry's type of network address.
Network address mapped to the entry's MAC address.
Interval (in minutes) since the entry was entered in the table.
MAC address mapped to the entry's network address.
Interface (VLAN or loopback) through which the entry was learned.
Specifies the IP address of a device on the network. Valid values are IP
addresses in dotted decimal notation.
Specifies the 48-bit hardware address corresponding to the ip-address
expressed in hexadecimal notation.
Age (min) Hardware Addr
0 0003.4712.7a99
- 0002.1664.a5b3
4 00d0.cf00.4b74
Age (min) Hardware Addr
- 0002.1664.a5b3
Age (min) Hardware Addr
0 0003.4712.7a99
Interface
Vlan1
Vlan1
Vlan2
Interface
Vlan2
Interface
Vlan2
Enterasys C3 Configuration Guide 25-13
arp